Printable View
ok had a ton of codes after what was supposed to be a break job but changed spark plugs as well. car would idle very rough and then die after about 5 seconds. cleared most of them but 3. still stuck with p2110 2106 and 161b. replaced plugs and wires, ignition coil, air intake hose, and throttle body unit. now the care will run in idle but still no response from gas pedal and still have those 3 codes. what else do I need to do? I have a 2007 aveo 5 manual no A/C
Here is someone else here who had a similar issue:
http://www.aveoforum.com/forum/f108/...e-codes-13807/
Looks like replacing the throttle body fixed his issue.
If you're interested, I think I still have the throttle body from the 07 engine I put into my 05. The 05 is cable driven, so I didn't use the 07 part. I'd let it go real cheap.
I already replaced the throttle body that was the last thing I did. and it did make an improvement but still got the codes and still can't get any response from gas pedal
Are you saying it was running fine with no issues before the brake job was done?Quote:
Originally Posted by haynayboy
If that's not the case, what's the complete history on this problem?
Yeah ran good up till then. Well I guess that's not entirely true. When I would accelerate while turning on to the highest it would fell like it would skip once in awhile. Hardly noticeable
But other than that it ran gone. Started fine and got me around without any other trouble
And since my first post I have also replace my map sensor and fuel pump with no improvement
Have you checked the brake booster hoses?Quote:
Originally Posted by haynayboy
no I haven't where are those located?
Hopefully someone owning an '07 (or access to a manual) can answer this.
ok thanks for your help. hopefully I can get this thing going. I can look it up. :)
ok so I disconnected the catalytic converter and it will run now. but now I am getting p0300 and p0301 misfire on cylinder 2 and random misfires