-
HUB Assembly HLP Plz
I am currently trying to replace the wheel bearing on my 07 Aveo. I have the axle nut removed as well as the caliper and can disengage the control arm and Tie rod when I need to, however I am having difficulty removing the Hub and rotor to gain access to the wheel bearing. How do I do this? I have also stripped one of the screws on the rotor.
My question is, do I need to remove the rotor in order to take the Hub off? Also, am I missing any steps to do this repair properly?
Thank you
-
i havnt had the hub of my aveo yet but heres a video should be same procedure,you need to mak sure you have found all 3 bolts that hold it in place.How To Install Replace Front Wheel Hub Bearing GM Front Wheel Drive PART 1 1AAuto.com - YouTube good luck
-
heres a video for a tool you could make youself if your hub is corroded and seized into its seat.Hub Buster - YouTube
-
drill out the tripped screw, the rotor will come off. you need the axle out of the hub to get to the bearing.
the hub does not have the 3 bolt gm design, it is strictly pressed bearings and a c clip.
get the spindle off, then take out the bearings.
-
Tried everything, drilled out the screws and nothing the rotor is still attached and i cannot get to the wheel bearing.
-
I cant remove the brake rotor at all from the assembly, and therefore cannot get to the assembly
-
Ok finally removed the rotor! But it appears that the hub assembly is pressed onto the spindle arm, rented a hub puller to remove hopefully this works, if anyone else has suggestions please let me know!!