Back seat won't lock after being down for work

[logodave]

Today I had to replace the fuel sensor on the fuel pump. I did this and when finished I have tried to put the drivers
side back seat and the notch is missing the locking mechanism by about a half an inch. The passenger side closes and locks fine. So WT? I have checked all the seat belts and the locking parts and they are all there, nothing is
causing the seat be off by that much but it is. I spent an hour on that alone. I finally just locked a shoulder strap and and a sealt belt to hold them in place while driving tomorrow. Either I did something wrong to make it that way or it's
always been that way and I am just now discovering this on my 2007 Chevy Aveo5. Any suggestions? Thanks, Dave

[Enxebre]

I'm guessing the cover of the fuel pump is not aligned properly.

[logodave]

I never moved the fuel pump. I simply replaced the sensor which is a very small part on top of the fuel pump. It's also in an
area under the seat which has nothing to do with the back of the seat. Thank you.

[EAD15]

Is it missing high or low? Did you remove the seatback while working on the fuel pump? There's a lot of important details missing in your post.

Also, consider posting a picture of the problem and the hinge points

[logodave]

It's missing the latch below. I did not remove the seat. I pulled the 2 rings forward on both sides and the seat lifts up without
removal. I will post a picture tomorrow. Thank you Enxebre and EAD15.