•  
    Results 1 to 1 of 1

    Thread: Cam shaft and sprockets during waterpump/timing belt replacement

    1. #1
      What's wrong with my car?
      Join Date
      Jun 2015
      Location
      ohio
      Posts
      13
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      Cam shaft and sprockets during waterpump/timing belt replacement

      2006 1.6L 132k miles

      Bad water pump.

      Hello,

      Replacing the water pump and doing the timing (albeit 30k miles less than required, but since I'm in there I might as well do it all) and don't want to deal with setting the cam sprockets and was thinking about attaching a wrench to the cam shaft to hold it in place while I remove both sprockets; can that be done without damaging anything? The cam and crank are currently set tdc. Will be loosening the water pump bolts to remove the timing belt and don't want to deal with setting the timing again after I get everything removed and replaced, so that's the reason for the question.

      Thanks

      EDIT: So, I went ahead and removed the water pump without having to remove the sprockets (the timing cover easily bends enough to remove and replace water pump without having to remove cam sprockets) and my intake cam is now off one tooth which I'll crank counterclockwise to reset; put belt on, adjust water pump to align with tensioner mark, spin crank twice to assure tdc, tighten everything up...





      Last edited by Aveo123; 09-01-2018 at 04:24 PM.

    Similar Threads

    1. Replies: 1
      Last Post: 08-25-2018, 02:48 AM
    2. Replies: 0
      Last Post: 08-22-2018, 09:52 PM
    3. 2009 aveo5 Lt 1.6 question about cam sprockets (timing)
      By Icecheez in forum Troubleshooting and Maintenance
      Replies: 8
      Last Post: 06-18-2018, 03:50 AM
    4. Cam shaft position sensor problems
      By Texasguy in forum Engine & Drivetrain
      Replies: 0
      Last Post: 09-20-2016, 04:46 PM
    5. 2007 Aveo 52000 miles cam-shaft timing belt to early?
      By kentucky in forum General Discussion
      Replies: 1
      Last Post: 01-15-2011, 01:43 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •