•  
    Page 3 of 3 FirstFirst 123
    Results 21 to 27 of 27

    Thread: U0100, and P0700 popping up

    1. #21
      What's wrong with my car?
      Join Date
      Sep 2014
      Location
      United States
      Posts
      14
      Thanks
      0
      Thanked 0 Times in 0 Posts
      when does the ECM come?



    2. #22
      Aveo Whisperer 06T200's Avatar
      Join Date
      Aug 2014
      Location
      530
      Posts
      625
      Thanks
      56
      Thanked 90 Times in 77 Posts
      It landed at our door Monday. It goes to the dealer Friday morning with the car for install.

    3. #23
      Aveo Whisperer 06T200's Avatar
      Join Date
      Aug 2014
      Location
      530
      Posts
      625
      Thanks
      56
      Thanked 90 Times in 77 Posts
      Ok got the car in on Friday morning, new ECM installed and was able to pick it up a couple hours later. They cleared the codes and due to the half day holiday schedule the tech was not able to test drive it. So I get about two blocks from the dealer, and just like a ghost in the machine, MIL light's up, and right back into limp mode. Oh that was a fun moment! So dealer is closed by then, so I just suck it up. Once I got time I went over all the schematics for the ECM/TCM, G103, power feeds, grounds, etc. I noticed one connector C101 that I had missed when I was checking the harness a month back, and everyone else may have missed as well, it is down under the coolant tank, just getting to it was a bit of a challenge. It wasn't dirty or corroded, so I cleaned it with q-tips and cleaner, and silicone greased it. It may be going back to the dealer, but since I cleaned that up the U0100,P0700,U0073 are not popping up every few blocks. Who knows at this point.

    4. #24
      Aveo Whisperer 06T200's Avatar
      Join Date
      Aug 2014
      Location
      530
      Posts
      625
      Thanks
      56
      Thanked 90 Times in 77 Posts
      Update: I think five months of no MIL, no limp mode, no anything is a sure sign C101 was in fact without a doubt the actual CAUSE of these errors. - Maybe make this one a sticky?? I think my last post was not clear since this was such a long drug out problem, but I attest it has been resolved, not by new ECM, not new TCM, - but C101.

    5. #25
      What's wrong with my car?
      Join Date
      May 2022
      Location
      Minnesota
      Posts
      2
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Where is the C101 ground on a 2010 Aveo LT? I cleaned 2 by the battery and ECU but still getting the P0700 and U0100 codes.

    6. #26
      Aveo Whisperer 06T200's Avatar
      Join Date
      Aug 2014
      Location
      530
      Posts
      625
      Thanks
      56
      Thanked 90 Times in 77 Posts
      Quote Originally Posted by copper View Post
      Where is the C101 ground on a 2010 Aveo LT? I cleaned 2 by the battery and ECU but still getting the P0700 and U0100 codes.
      On a 2010 I couldn't tell ya. If you can get access to the TIS wiring schematic, it will show the locations of all connectors. This set of codes indicates a faulty connection on the CANBUS between the PCM/ECU and the TCU. Find this circuit, and check ALL connectors along the circuit. One should be dirty/corroded, or a loose/broken wire. I lost access to the TIS library sometime around 2019, so I can't look it up for you. Sorry.

      Best of luck, I know this one stumps a lot of techs.

    7. #27
      What's wrong with my car?
      Join Date
      May 2022
      Location
      Minnesota
      Posts
      2
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by 06T200 View Post
      On a 2010 I couldn't tell ya. If you can get access to the TIS wiring schematic, it will show the locations of all connectors. This set of codes indicates a faulty connection on the CANBUS between the PCM/ECU and the TCU. Find this circuit, and check ALL connectors along the circuit. One should be dirty/corroded, or a loose/broken wire. I lost access to the TIS library sometime around 2019, so I can't look it up for you. Sorry.

      Best of luck, I know this one stumps a lot of techs.
      Thanks 06T200, Ill keep looking!





    Page 3 of 3 FirstFirst 123

    Similar Threads

    1. U0073, U0100, and U0101 codes
      By feather12comp in forum Troubleshooting and Maintenance
      Replies: 3
      Last Post: 12-22-2019, 11:50 AM
    2. Code U0100
      By Seagreenmachine in forum Troubleshooting and Maintenance
      Replies: 3
      Last Post: 05-29-2016, 09:02 AM
    3. 2006 aveo p0700, u0073, u0100 codes
      By tobs in forum Troubleshooting and Maintenance
      Replies: 9
      Last Post: 07-30-2014, 01:59 AM
    4. popping noise
      By abartl in forum Wheels, Tires, Brakes & Suspension
      Replies: 4
      Last Post: 06-06-2013, 05:23 PM
    5. Codes P0700 and P1781
      By djmarch in forum General Discussion
      Replies: 2
      Last Post: 03-21-2012, 12:42 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •