Printable View
I couldn't find any help using search so I am starting a new thread asking for help. My daughter just bought a 2007 Wave sedan and the HVAC blower is not working. I have no voltage anywhere at the resistor pack or blower motor. The manual list fuses and relays for the HVAC blower for the hatchback model, but the sedan model has a different fuse layout and there is no fuse or relay listed at all for the blower. Any help or advice would be appreciated. Thanks in advance.
Never mind, but for future reference there is no fuse or relay for the blower in the Wave sedan, the circuit is powered directly from the ignition switch "Run" (which is already protected by a 30amp fuse) position through the blower speed switch then to the resistor/motor assembly. I have proven it to be a bad switch. Thanks.
hey man, i hope this works on my car. thx for posting your results.
how did you install?
Pull the knob of the speed switch. Pop the 3 sided trim piece off around the radio, pop out the rectangular trim piece below the HVAC controls. This exposes 4 screws, remove them. You might have to release a couple of the cables behind the panel to get it out far enough to work on. Un-plug the blower speed switch. There is a little plastic lock that keeps the switch assembly from turning, press very slightly on this and turn the switch assembly and voila, the switch is in your hand. I never got my new switch yet, it should be in in a couple more days, I did how-ever take the old switch out and refurbish the contacts in it to get my daughter going until the new switch comes in.Quote:
Originally Posted by stanzz
let me know if it works.
I am not sure I know what you mean. As I stated earlier, I proved the switch was defective and I took the switch apart and refurbish the contacts to get it working again. Perhaps you meant let you know if the new switch works?Quote:
Originally Posted by stanzz
yeah, i just meant to let me know if the switch works correctly.
The new switch just arrived. I will not have a chance to put it in until tomorrow. I will let you know how it went.Quote:
Originally Posted by stanzz
Had a chance to put the switch in yesterday, it was slightly different than the old one so I had to do some minor modifications to it. It is working fine.
Where exactly is that fan motor and resistor located. I have a 2007, and find there is no Haynes manual or any other that I can find. Is it in the engine compartment or the passenger cpmpartment? I am having similar symptoms.....Fan does not work no matter which setting I turn it too. The AC kicks in OK, but no blowing from the fan. On another note, are there any other manuals available besides the factory one?
MadMike