-
Re: Thehunterooo's Aveo
lol yup, the extra space was worth it though, plus the pipe was not long enough, and the filter still is not on all the way, so i really had no choice in the matter, which is the main reason i have not bought a bypass, i will have to run into a foot deep of water to have any chance of trouble
-
Re: Thehunterooo's Aveo
the tach works!!!
replaced the leds in my gauge after the two were duds, and found that one i put in is another dud, so im just going to leave it in there for a while
too damn hot though, the strut bar is on hold again lol, 95 degrees is too much for me :P
-
Re: Thehunterooo's Aveo
95 is chilly in Florida. lol.
-
Re: Thehunterooo's Aveo
-
Re: Thehunterooo's Aveo
the bolts are too big for the holes for the strut bar, and a bolt ended up falling behind the ecu so it is a no go until winter, nothing seems to work out lol, i am taking a long break
-
Re: Thehunterooo's Aveo
:lol: :lol: you're funny, dude. Did you at least get that bolt out?
-
Re: Thehunterooo's Aveo
Come up here! It's only about 87. :) Less humid though.
I was messing around today cutting rusty bits out of a floor pan. I'll save the welding for later though, when it's winter.
-
Re: Thehunterooo's Aveo
bolt fell behind the ecu, the one that larsbud had to grind off to fit the bar, i could not get it out as it looks like there was one more bolt at the bottom, i wish i had a place to work at but outside on an open concrete slab is not ideal, and people always look at me like im crazy #-o its 97 out right now btw
next day i have off i think ill go to lowes and get smaller hardware and get it down, its a piece of cake if the bolts fit right
i think this week ill send that dash piece up to mike for the 52mm gauges
-
Re: Thehunterooo's Aveo
Are you sure you wanna go with a smaller bolt for this application? if it snaps off it will hit the tire, bounce, and get stuck in the rear wheel or something.. :shock:
-
Re: Thehunterooo's Aveo
lol not that smaller, just enough where i can get the bolt through the hole, there is no way those two that came with the bar are fitting in, unless i increase the size of the hole